Stop
Flipping.
Start
Building.
Scan a QR code and land on the drawing for the room you're standing in. Every device gets a photo, serial and model before it's covered, so you have a record of what your crew installed, and the proof to back it. Here's what that looks like for your trade today.
One record. Every trade on the job.
Each trade has its own headaches. The promise is the same for all of them: a record of what your crew installed, captured at the wall and pinned to the drawing.
Electrical
Which receptacle ties to which circuit? TradePlane reads your panel schedules and ties each device to its circuit and panel, right on the drawing. Every device your crew sets gets a photo, serial and model before the wall closes, so the record of what went in is yours, not a guess from the drawing.
Plumbing & Pipefitting
The fixture got moved for the casework. The valve sits behind the grid, not where the drawing puts it. Your crew records each fixture, valve and piece of equipment where it actually went in, with a photo, before the ceiling closes, so the next person to look for it doesn't have to open three tiles to find it.
Mechanical & HVAC
Units get swapped, substituted and moved during the job, and the drawing doesn't follow. TradePlane pulls your equipment off the mechanical schedules, shows what each unit serves and what feeds it, and keeps the unit's photo, serial, model and submittal on one record.
Fire Protection
Inspectors, the AHJ and the owner's next vendor all need to know what went in and where. TradePlane recognizes your fire devices on the drawings, each one at its spot on the sheet, so your record of what went in starts from the drawings, not from a blank page.
Low-Voltage & Technology
Data drops, card readers and devices disappear above ceilings and behind walls faster than anyone can document them. Your crew pins each one to the drawing as it goes in, with a photo, so it can be found again without pulling cable to trace it.
Built for the person holding the phone.
Daily Reports From the Same Scans
What each crew captured and moved forward shows up in the day's report for electrical, plumbing and HVAC.
Works From Your Phone
Runs in the phone's browser, no app, no password. Crew members get a text-message code once they're added to the job.
Fewer Trips Back
Every device is pinned where it went in, with a photo. When someone asks what's behind a finished wall, you pull it up instead of sending a crew back.
What foremen ask first.
Do my crews have to download an app?
No. TradePlane runs in the phone's web browser. Crew members log in with a code sent by text message, no password. Someone on the job adds them during setup, so a stranger can't scan their way in.
What happens when the drawings get revised?
Devices you've already captured carry over when a sheet is reissued at the same page size. If the page size changes, that sheet has to be set up again.
Does it pull submittals?
Submittals can be linked to any device. HVAC equipment also gets the submittal and spec sheet on the unit record. TradePlane doesn't run submittal review or approval.